SpiderBot Delta 3D Printer

SpiderBot v2.2


The Delta 3D Printer with all the features you can dream of
Optimized for ABS...


Find Out More

SpiderBot Dual Extruder


Order your printer with Tilting Dual Head

or as a separate upgrade.


Find Out More


Three Spheres System (TSS)


The Extrusion Head is supported by a single plate
with only 3 Spheres and the Rod-End magnets.

The TSS is a combination of magnets with spherical bearing surfaces at every end of the
6 carbon tubes connected to three spheres on the support plate that holds the extrusion head.

More Details

Hi-Temperature Full Metal Head

The Full Metal Extrusion Head works up to 360°C



"High Temperature" extruder option available. This will allow for extrusion at
temperatures in the range of around 360°C.

More Details

Frequently Asked Questions

  • Was everything designed and created from scratch?

    No, of course not, we were inspired by the work of:

    • Dr. Clavel at the University of Lausanne for the Delta Technology.
    • Johann Rocholl, for the Delta geometry with linear guide.
    • Mr Werner Berry, for magnetic Rod-ends.
    • "Sousoux" for porting the Delta technology into the Repetier Firmware.
    • Hot-World GmbH & Co. KG for Repetier Firmware and software
    • Arduino community
    • Lonesock for KISSlicer
    • And, of course, all the RepRap community...
    A big thank you to all of these people for their fantastic work.
    The design of the:
    • Three Sphere System
    • Extruder with Dual Drive
    • Dual Extrusion head
    Are all exclusive to SpiderBot.
    Created by Ph. Boichut on 10/01/2014 in Frequently Asked Questions